IMS Passive Infrared Detection Sensor - IMS-4861

The IMS-4830 Water Detection Sensor detects the presence of water on a floor or in a false ceiling. Up to three WaterRopes can be cascaded from a single IMS channel to extend the reach of each sensor. Water sensors can be daisy-chained for greater coverage. This unit includes one (1) 10ft. WaterRope sensor.

You can use this Water Detection Sensor to monitor for the presence of water.

This is an external fluid detection sensor for the EVR 1500.

This liquid detection sensor is the perfect addition for your system. This will alert you at the first sign of flooding and can be used again and again due to being 100% waterproof. It detects all water except for dionized water and supports Cat5, Cat5e, and Cat6 through an RJ-45 connection.

The Sensaphone Water Detector senses the presence of water via the attached WaterRope. The Zone Water Detector can be used with most models of Sensaphone. The size of the monitored area can be extended by attaching additional lengths of WaterRope (sold separately) to the end of the included WaterRope. You can connect up to ten (10) lengths of WaterRope (100...

This is a wall mount humidity sensor designed to detect if humidity is too high or too low. Alarm limites are adjustable from 10 to 60 percent and it works with all Sensaphone products.

This unit can be placed anywhere or mounted on the wall or ceiling. Using Passive Infrared (PIR) technology, this alarm unit can designate a protected zone up to 15 feet in a 90 degree sweep from the device. If an intruder trespasses into the invisible protected zone, PIR motion detection triggers the loud alarm.

The IMS-4810 temperature sensor is designed to connect to the IMS-4000 Host or Node (available separately) and monitor indoor temperatures. The electrical connection between the sensor and IMS-4000 is made via RJ-45 patch cable (not included). The sensor may be mounted either on a wall or to a single-gang electrical box.

This miniature temperature sensor connects to your existing IMS-4000 Host or Node via an RJ-45 jack. Because the sensor utilizes your existing Category-5 structured wiring system, no special wiring or schematics are needed to install them. Simply locate where you want to place the sensor, attach a standard patch cable, plug it into your patch panel and do the same...